Design Of Tongue Like Shoes

The split tongue structure or whole tongue structure is arranged on the female shallow shoe, which forms a variant design of the tongue like shoes, which can increase the variety and style of the women's shallow shoes.

1. imitation broken tongue type change
The fake tongue tongue shoes are very similar to the ordinary tongue type shoes, but the positions of the mouth are relatively close, so they do not need to take the handle. But it does not mean that you do not take the stilts, because the stilts are already on the half panel. The front tip of the shoe is lowered and the toe and toe joint is raised to form a three-dimensional state, which meets the requirements of the last surface.

As shown in figure 3-3-1, the broken tongue is equivalent to a shoe tongue on the basis of a square door or a round door, so after the connecting midline is designed, the shoe contour is designed first, and then the tongue is designed. After the design of the back package to solve the problem of opening. The dorsal midline of the broken tongue should be taken at the 1/2 angle between the extension line of the front middle line and the back middle line. After setting the length of the shoe tongue, the contour line can be directly designed, and the width of the mouth door will be O'point. Because the width of the shoe has the difference between the inside and outside, so the width of the tongue must have the difference between the inside and outside. The O in the heart is located at the front and back, which is consistent with the requirement of the full shoe. The rest is designed with round shoes.

In the case of Li Huai's continuous help, if you want to pick up the waist socket craft, you should first assume that the waist is broken, play the cut, fill up the stilts, and then stick the position where the hook is fixed. As shown in the diagram, the dotted line is shown.

If you want to design the cross arm, you need to design the broken tongue shallow shoe, then match the cross arm. Unlike the full length shoes, the height of the cross arm does not need to be further upgraded to 3mm, and it can fall directly on the back line of the front and the tongue.

Why not design the shoe tongue directly on the back midline VoE? Because there are stilts on the half panel, the VoE line will increase when the front midline of the front is lowered while the front is stretched. If the tongue is designed on the VE line, the tongue will be raised without sticking to the shoe last.

2. imitating whole tongue changes
As shown in Fig. 3-3-2, the length of the tongue is directly intercepted after the Jvo is connected to the back midline, and the length of the tongue is about 30mm. Then the outline of the tongue is designed. Note that the inflection point of the tongue is controlled near the 0 point and the difference between the inside and outside is wide. The rest is designed with round shoes. After the Huai Gang, we design three color stripes to solve the problem of opening materials.

From the appearance, this shoe is very similar to the structure of the whole tongue type shoe, but the two doors have different location. One after the V point, it needs to be handled in a step. One can be directly designed near the Vo point. The basic reason is that the saddle shaped surface is acting like a monster, and the female shallow shoe avoids the saddle surface, so it does not need to take the changeover. Because the whole tongue shoe belongs to the structure of the dark door, the key point determining the location of the dark door is the width of the mouth door.

3. changes in imitation tongue twisting
Tongue twisting is a change of the tongue, and the tongue is turned into the tongue of the shoe after it is joined to the shoe, thus forming the overlapping tongue, so it is called "roll" tongue. The tongue is often cut out to make fringes with good decorative effect, as shown in figure 3-3-3.

This is a design drawing of L-12, drawing the finished product diagram, understanding the structure of the shoes, and then drawing the structural design plan. The shoe is straight and easy to insert. The location of the scissors is attached to the picture.