Simple Explanation Of Different Ways Of Shoulder Saving

When

There are many commonly used methods of shoulder handling in the shoulder area. The three most common methods are:

1, the suture should be sutured to the shoulder, or only one half of the suture.

2. Fold the dart.

3, divide the provincial road into several small provincial roads that are not processed.

Replacing the dart with folded forms can also shape the human body very well.

And because it is folded, the original shoulder line will be turned into a curve so that the shoulder line can be straight after folding.

The highest point corrected by shoulder line is at the center of the provincial road, about 1.5cm from the original shoulder line.

After merging the original shoulder dart and pferring the dart to the cut under the armhole, three parallel lines can be drawn on the shoulders as the position of the pleat.

The middle line is exactly the original shoulder line, while the other two lines are 2-2.5cm on each side.

They are about half of the length of the original dart, and are eventually collected to the original provincial point.

Cut these lines, cut them from the shoulders to the chest points, then move slightly behind the paper, and divide the three folds into the three fold by merging the cuts under the armhole.

Fix the three folds with pins or glue on the paper.

Increase shoulder area

Sometimes, in order to get tighter or more fitting effects, it is necessary to increase the provincial road. Most of the cases appear in very fitting styles, such as "pleated" tops, bathing suits, tights, underwear and prototypes, but not on the side of the front centerline.

Generally, it will increase by half or twice the size of the province near the shoulder point.

:

In order to get loose effect on the chest, sometimes it will cut the shoulder area smaller.

This method is very necessary for some special styles, such as a less fitting blouse or a daily T-shirt changing style, and sometimes to suit some body shape requirements.

In general, the shoulder is shortened from inside the outer line to the inside, and then the armhole is redrawn from the new SP point.

Small provincial roads such as these are usually slightly shorter during stitching.

Temporary movement of shoulder provinces

In many styles, the "move" to other locations at the very beginning will be shifted to "permanent".

The required location is either temporarily pferred to facilitate the drawing of the structural line of the garment piece in this state.

In the pattern, cut from the position of the actual bust line under the armhole, until the chest point is X, then fold the shoulder point at the chest point X for the provincial cusp and replace it with a pin.

A cut opening will appear under the armhole.

This gap indicates that the shoulder load has been pferred to a new location, and it will not obstruct the drawing line of other parts of the garment.

After drawing the structural lines of other parts of the style, the shoulder province can return to its original position.

For example, you can simply remove the original pin from the shoulder, and merge the dart under the armhole, or take the adhesive tape and other methods, such as pins or paper, to complete the merger of the provincial road.

After completing the conversion, the "temporary cleft" will not be in the pattern.

It worked.