Picture And Text Crack The Work Flow Of Garment Factory

Many people came out of school and did not understand the specific operation procedures of garment factories. They often encountered many problems in their work.

Now let's follow the camera to familiarize ourselves with all the work of the garment processing plant.

Garment factory workflow: Chapter 1

First of all, some of the process flow of the garment factory is cloth. The cloth that comes back from the cloth mill is placed in the warehouse.

This is the "cloth inspecting machine".

As for cloth inspection, every factory will have a standard. If it exceeds this standard, the whole batch of cloth will be rejected or the manufacturer will be reworked.

This is the "defect map".

After the cloth is finished, the cloth with a mass of OK will be sent to the steam engine to pass over the air and loose cloth to maintain the stability of the cloth area. If some special cloth is cut directly without 72 hours of loosening time, the size deviation will be very large after the work is done, and the general cloth will be put flat for 24 hours.

After pine cloth OK, it can be cut.

First, computer cloth.

This is "computer bed cutting".

After the cloth is cut off, there will be a department to be responsible for the problem. If there is any problem, check it directly to facilitate the subsequent process.

After checking the film, some factories will have a medium ironing section, and the middle blanking department is mainly ironing some semi finished products with some ironing.

This is "

Semi finished products.