The Basic Principle Of Shoe Last Design -- Knowledge Of Sticking Last

1. whole last sticker method

When the surface is asymmetrical, it must be attached to the whole last.

First, cut the 2/3 according to the center line of the sticker, then place the center line of the sticker on the front line of the shoe last, and paste it on the last surface.

Two to three tiny scissors are placed in the concave part of the last, so that the last surface is smooth.

2. half last sticker method

For the inside and outside of the upper and outside, the pattern is symmetrical.

The method is to cut out a paper slightly longer than the shoe last, tie it on the outside side of the shoe last, and cut three cuts on the concave part of the last, then take a small piece of sticker to fill the three gaps.

3. full and empty waist stickers.

It is used for sticking sandals on the surface of sandals. Generally, two pieces of paper are cut out according to the length of the front and the rear wing. The size of the surface is slightly higher than that of the other ones, such as cutting the mouth at the most concave part of the deep hole.

4. empty space and full waist sticker.

For women's sandals, stick to the last, and cut out a piece of paper which is slightly shorter than the last length 1cm. The center line of the paper is aligned to the center line of the shoe last, and it is pasted into the inside and outer ring of the last. If the head is empty, the 1cm can be set aside, and the lower part of the rear part can be cut off to make it more reliable.