Basic Introduction Of Shoemaking Equipment (Three) Forming Machine / Box Opening Machine

< p > automatic carton < a > molding machine < /a > automatic carton opener is a large number of carton automatic open, automatic folding lower cover, automatic sealing bottom belt of the assembly line equipment, the machine uses PLC+ display screen control, greatly facilitate operation, is a href= "http://www.91se91.com/news/" automation "/a" scale production essential equipment.

< /p >

< p > characteristics of forming machine < /p >

< p > (1) the computer of the molding machine adopts the computer chip of the imported PLC, matching the LCD screen, the software backup fault self diagnosis system and the error correction function, making the operation more convenient, and the control program is designed by fool, without professional training.

< /p >

< p > (2) the whole hydraulic drive of the molding machine has the first step in China to create a stepless hydraulic frequency modulation technology, which solves the adaptability of the molding machine to various materials and blocks, improves the compactness of materials, and shortens the forming cycle.

< /p >

< p > the use method of forming machine < /p >

< p > 1, choose to flatten the table and stabilize the machine, so that the chassis can be pulled away to make the machine panel easy to observe.

< /p >

< p > 2, insert the plug on the hand-held inducer into the socket on the panel and tighten it.

Note the location gap < /p >

< p > 3, insert the plug of the power cord into the socket on the back plate of the chassis, and insert the other end into the power supply socket. Make sure you use the single-phase three wire power supply.

< /p >

< p > 4, open the power switch (POWERSW.) on the back panel of the chassis, press the key of the panel "power switch (SWITCHING"), and wait for "WARMUP (") "green indicator light to light up, so that the machine can work.

< /p >

< p > 5, hold down the setting button (SETTINGBUTTON) button and set it to the right value, usually between 0.5-2.0 seconds.

< /p >

< p > 6, put the sensing head on the top of the container and press the start button on the handle. At this time, the "red HEATING" indicator lights up, indicating that it is heating, and the sensor should not be removed. After the "red heating" (HEATING) "red light" is turned off, the sensor will be removed. When the green indicator light is on (WARMUP) or the buzzer in the aircraft is short, the "beep" prompts the sealing operation of the next container.

< /p >

< p > 7, check the sealing quality. According to different materials, diameter containers and production efficiency, properly fix the "SETTINGBUTTON button" to make the sealing quality the best.

< /p >

< p > < a href= "http://www.91se91.com > > working principle of forming machine < /a > /p >

< p > the working principle of the molding machine is similar to that of the injector. It uses the thrust of the screw (or plunger) to inject the plasticized molten state (i.e. viscous flow state) of the plastic into the closed mold cavity and solidify the product to obtain the product.

< /p >

< p > injection molding is a cycle process. Each cycle mainly includes: quantitative feeding, melting, plasticizing, pressure injection, mold filling and cooling.

Remove the plastic parts and then close the mold for the next cycle.

< /p >