Experience: Ten Reasons For Embroidery Walking

造成繡花走位的原因主要有以下十種：

In the 1. page, the bottom line is too close to the edge of the object.

2. the line used for the bottom is too thin or the angle is not correct, so the cloth can not be well fixed.

The 3. edition should be played from the center to the periphery as far as possible, so that it is more stable in the production process.

4. during the production process, because of the repeated use of double sided adhesive tape, the viscosity is reduced, and the cloth can not be fixed.

5. due to the aging of the machine, the precision decreases, causing some walking out. For example, the same batch is embroidered, some of them are normal and some are walking.

6. it is obvious that cloth is placed on the lint cloth due to the location of fluff on the surface of cloth.

7. because the paper is too thin under the cloth, it can not be well lined with cloth.

8. the pulling force of the embroidery machine must be strong and not too strong, otherwise it will change easily.

The 9. edition should consider the overall rationality of the needle; if you don't walk a single needle in one place, then run straight to a large flower far away from the needle, then come back and wrap it up with a pin. This way is very common. Software is invisible, and it changes on the embroidery machine.

10. increasing the number of lines changing will reduce production efficiency, but the possibility of walking will be reduced a lot.