Home >

Using The Common Knowledge Of The Front Machine

2008/12/3 10:48:00 41926

??? 日本語 Fran?ais English 中文

Guangdong coastal areas in recent years, the shortage of workers, coupled with the increase in shoe factory orders, more and more factories try to use the front machine instead of hand climbing shoes. Our company has been engaged in shoe making machinery for many years, and has successfully guided the shoe factory to use this machine for many times. The efficiency of the front gear is very high. It has explosive production capacity and can receive large orders. The average daily output of 10 people can reach 1000 pairs. Manual processing can be done at most 400 pairs, but many factories are not familiar with the front gear, and can not fully display the functions of the machine.

The following points should be noted in the pition from hand climbing shoes to machine climbing shoes.

I. matching equipment

The shoe shaping machine, the rear bell setting machine, the shoe softening machine and the rear steam evaporating machine;

Two. Requirements for board rooms

The hand is much bigger than the machine plate, the first is the waste of raw materials; the two is that the toe of the shoe is very uneven, causing hair angle or sweep the shoe upper.

The machine plate requires proper material opening, especially for the high whip surface.

Three, matching shoe materials

If the middle sole exceeds the shoe last, if it is used, the scissors should be trimming or slightly smaller than the toe part. For the special head of the shoe, the front part of the middle sole will be slightly glued with white glue or double-sided adhesive when the warpage is bigger. In short, the middle sole matches the toe of the shoe, with a mesh of silk floss on the surface to enhance the adhesive force; the middle bottom edge is white latex with glue and shoe upper corner, and the ratio between the port treasure water and the quick acting agent is moderate, too dry and too wet has great influence on the binding effect.

Four. Skilled operators.

The front hand is long hand, the thumb is flat wide, the gestures are correct, the upper and heels should be clamped.

Five. The new type of body should be manufactured before the machine is used when hitting the confirmation board.

When there is no problem, just put the same code and turn to mass production. The former helpers must cooperate with the planner to test the plank and repair the board, so as to ensure the smooth production of the site.

Six, mechanized production is a production mode that is coordinated by many departments.

It is the key for all production departments to cooperate closely.

It is suggested that the use of the group piece model will facilitate the process.

Editor: vivi