Variant Design Of Shoes In Shallow Area

With the foundation of shoes around the round mouth, various variant designs can be carried out.

For example, we should change the straight area into oblique belt, double belt, handle belt and foot girth.

Tape and so on.

Design of 1. oblique belt shoe with shallow mouth

Slant area refers to the shoe strapped to the instep.

The color picture L-24 is an oblique belt.

The diagonal belt broke the rigidity of the Striped shoelace and produced a sense of motion: generally, the position of the shoelace is in front and the position of the outer shoe is at the rear, as shown in Fig. 3-4-4.

The shoelace designs a shoe table in the position of the shoe. The shoelace is pulled out from the shoe table, and it reaches the back midline and folds outward.

In the reverse position of the midline, the direction of the drill belt is determined by the principle of "reflection angle equal to the reflection angle".

The instep also raises 5mm, and the rest is designed with shoes around the round mouth.

2. pairs of shallow shoes design

Double belt is to use two shoelaces instead of a shoelace, this is to increase the shoe color changes, so that the shoe is full.

The double bands can be parallel, or can be handed in meaning, see figure 3-4-5.

The two shoelaces are designed inside and outside the mouth of the door, and then fold to the rear side, there will be a cross in the back midline position.

It is equivalent to designing two oblique belts, as shown in the dotted line and solid line.

Because the shoe drill is assembled on the outer side of the shoe, it has a regulating function, and the shoelace on the side is fixed, so the end of the shoe lace should be replaced with the rubber band of about 30mm in length.

Other designs are shoes with round mouth.

Design of shoe with 3. feet and shallow mouth

The foot girth is a shoe with a shoe with a shoe that is bent in the corner of the foot.

As the foot girth is not enclosed in the wrist position, it is not possible to use the data of the wrist, but to control the length of the shoelace to the E point, as shown in figure 3-4-6.

The rear end of the foot band is connected with the back pack of the shoe. The height of the back pack is about 30mm, including the width of the two shoelaces, the amount of loose after the break and the amount of stubble.

The back pack is formed into a ring sleeve, and the shoelace is worn through a human loop sleeve.

Because the shoelace is active, although it is higher than the normal back, it will not cause grinding feet.

The width of the belt is from 8 to lOmm, and the reference length of the shoelace is 2 * EQ, then the 16mm of the spikes and the 30mm of the shoelace are added.

The rest is designed with shoes around the round mouth.

The design of 4. handles with shallow shoes

The handle belt is a shoelace with shoes on the instep.

Shoelaces are relatively wide and are more common in girls' shoes.

The two shoelaces can be laced, shoe buckles, rubber bands or nylon buckles, as shown in figure 3-4-7.

Inside and outside the back band gradually extended to the instep, as if to pull hands, the shoe lace folded to the outer arms, with a Velcro connection.

After raising the 5mm on the back of the foot, the design of the handle belt is carried out by using the back control line EP, and the bandwidth is 15 to 20mm.