Basic Quality Inspection Requirements For Leather Garments And Fur Garments

It must be soft, no residual defects, uniform color and no obvious color difference.

Never allow the use of rind, leather, coarse pores, and uneven brightness.

The same product should ensure the consistency of leather surface, pile, color and gloss.

There is no influence on the appearance of the louse bite, maggot bite, loose face, rib print, crack, dead fold, and collar peak.

Is Jupimau glossy and harmonious?

Carefully touch the fur, you should feel the velvet soft and soft, rather than rough and stiff.

Sew

Needle spacing is generally required for each 3CM of 9-10 needles, and the inside is 12~13 needles.

The mouth must be uniform and wide and narrow. The 0.2CM+0.6CM double check 0.2CM can narrow the 0.05CM to achieve the beautiful effect. The single stop line of.0.6CM can not have sitting potential, and the ends of each part must not be bent, spit or spit.

When sewing, no stitching can be done. The stitching must be smooth, straight and wrinkle free.

The position of the main label, size and washing label should be consistent with the process requirements and consistent with the model.

The accessories on the clothing should be fastness, no defects, and the buttons are in correct position.

The collar should be uniform and uniform in shape, symmetrical in shape and symmetrical in both sides.

The collar of the finished suit should be naturally flatten.

The middle and the lower should be straight and straight, not to be stirred up. The length of the buttons is the same, the zipper is smooth, the teeth must be neat and uniform, and the dark zippers should not be exposed.

Sleeve head and armhole should be round and smooth, with uniform eating potential, symmetry and length.

The cuffs should be straight and the size is the same.

The bag position must be accurate, the shape of the bag can not be out of shape, the width of the embedding bag should be consistent, and the four corners should not be wide mouthed.

The clothes that have a province must pay attention to the symmetry of the left and right sides and the plain clothes of the provinces.

Buttonhole

The size of the buttonhole should be the same as the technological requirements. The positioning must be correct, no skew should be allowed, the width of the line is wide, the four corners are square, and the thread of the buttonhole should be in place.

The side seam of all tops and bottoms should be straight and smooth without bending and wave.

Ribson must be very suitable. He must not be too long and too short. If he has cotton clothes, he must finish trimming cotton, and if he has silk jumping and silk spinning, he will not be able to use it.

There is no jumper line on the open line, there is no trace of needle holes that appear after modification, and the hem should be straight.