Remind: Try Not To Buy Children's Clothes With Rope.

Peng Shixiong said that as early as 2009, the state promulgated the standard for safety requirements for children's wear ropes and belts, and Safety specifications for children's tops.

The standard stipulates that the length of the exposed belt of the waist and hem can not exceed 7.5 centimeters, and the length of the other parts of the rope must not exceed 14 centimeters.

Peng Shixiong measured the exposed length of the sample A and sample C, and found that the length of the cord of the two samples exceeded 14 cm, which was an unqualified product. The measured values are 21 cm, 24 cm, 26 cm and 29 cm respectively.

Peng Shixiong said, too long rope belt is more likely to cause the rope to be caught in the gap, or stuck in the moving machinery. The most common case is the rope clip in the gap of the slide.

Peng Shixiong said the neck of a child is fragile. In particular, the development of children aged three or four is not yet mature, and the bones in the neck are more fragile. They are easily choked or even endangered when they are entangled or tied up by a rope.

about Rope belt The experiments fully proved the potential risks of children's clothing rope. Therefore, Peng Shixiong reminds parents, when buying children's clothing for children, we must pay attention to whether the rope length is up to standard.

Try not to buy collar for children under 14 years old, a rope on the hat, and a strap on the back. Children's wear Or remove the rope belt completely before the child wears it.

In addition to rope belts, accessories for children's wear, such as decoration. parts Buttons and labels can also cause fatal injuries to children.

Peng Shixiong tested the shedding performance of the sample B with accessories. The experiment was demanding. Peng Shixiong experimentation in a room with a relative humidity of 65% and a temperature of 20 degrees Celsius.

There are many plastic bead decorations on the sample B. Peng Shixiong selected one, and the lower clamp of the tensile tester was vertically clamped with plastic beads.

Then, Peng Shixiong pulled the plastic beads out, and after 2 seconds, the plastic beads fell off.

The tensile test showed that when the plastic beads fell off, the pulling force was 35 Newton. According to the standard requirements, such as plastic beads, the diameter of components is >6mm, and the minimum shedding strength should be 70 Newtons. The abscission property of sample B is obviously not up to standard.