Cutting Illustration: Cutting Method Of T-Shirt Stand Collar Pullover

　 I. Style Introduction:

This kind of fabric can be cotton, or thick chiffon, or other plain color fabrics, etc. are good choices. The material is generally taken as length + sleeve length + 6cm

The design of loose style, rounded hem, high stand collar and long placket is very characteristic and charming The sleeve is a loose and even sleeve design, which is natural, comfortable and full of leisure flavor, giving people a relaxed and free image. The design of gokf sleeve once again highlights the design style of this style, which plays a role of icing on the cake. The overall clothing style is strong, and students who like this style can boldly try.

　 2. Interpretation of cutting drawing plate making:

The bust is 18 cm relaxed and the sleeve cage is 26 cm deep. It belongs to loose style design, suitable for students weighing less than 125 Jin.

In the cutting drawing of the front piece, red is the plate making of the placket. After copying it to the right, note that the dotted line is folded in half. Therefore, the net line width of the placket is 10 cm, and two cuts are made. The shoulder falls 15 cm to the left from point a, and then 4 cm downward to produce a point. Then connect with point a to generate shoulder oblique line, and then take the shoulder width of 19 cm and pull it down vertically to the shoulder slope, The intersection of the points is extended 15 cm along the shoulder angle, and after the right angle falls by 3 cm, the sleeve slope will be generated by connecting the shoulder point. The rest is simple. You can combine the video to make it clearer.

In the cutting drawing of the back piece, after the back middle drops by 10cm, the connecting line goes out by 4cm to the right as the folding amount of the back middle.

The curve of the back collar is 8.9, especially the curve distance between a and B.

Along the line of the red area in the left figure, copy the front piece on the right, and then use the middle as the symmetry axis to form a large whole piece.

The left lower sleeve, which is copied from the red area on the right, is a large whole piece. If the fabric width is too narrow, the middle part can also be disconnected.

The drawing with the front and back pictures together is shown.

The upper sleeve on the left is copied from the red area on the right. If the fabric width is too narrow, the middle part can be disconnected.

The left lower sleeve, which is copied from the red area on the right, is a large whole piece. If the fabric width is too narrow, the middle part can also be disconnected.

3. Detailed explanation of sewing part:

The sewing head of the collar is not exposed on three sides. Students who can't sew can refer to my previous video for a detailed explanation.

The buttonholes of the sleeves can also be decorated with chain buttons and chain cufflinks, and an 8 cm overcast is made under the back middle yoke.

When the collar is sewn to point B, it will stop and sew with the placket.

The fillet position of the side seam and the bottom edge of the hem can be pasted, and the cloth can be folded and then stitched with 1 mm of open thread, so that the seam head can not be seen.