Design Of Side Zipper Short Tube Boots

The structure of a side zipper short boot is formed by grafting a single side opening structure to a low tube boot and connecting it with a zipper.

1. finished product drawing

As shown in Fig. 5-2-6, a zipper is fitted with a zipper tongue to prevent the zipper from grinding.

The front part of the shoe is disconnected, and the belt is used to cover the break line.

Shoe soldering is relatively large, commonly known as large drill zipper boots.

Notice that the front end of the boot is not raised but slipped, and there is a "gap".

 

In the back of the boot, you seldom see the insurance cover. It's not that it doesn't need to be strengthened, but it looks "cheap" with the insurance skin.

It is possible to make use of the post reinforcement and the uniform bar. If there is no opportunity to make up, it is necessary to make a covert patch on the back of the boot.

2. structure design drawing

As shown in figure 5-2-7, the height of the back of the shoe is 15 0mm, and the width of the opening is 125mm.

Because the opening and closing function of the unilateral opening shoes is smaller than that of the inner ear shoes and the outer ear shoes, the width of the cylinder mouth is increased, the male boots are taken from 140 to 145mm, and the female boots are taken from 125 to 130mm.

 

With the increase of the back height, the camber of the back arc should also be tilted back.

In addition to satisfying the physiological structure of the foot, the inclination should also be considered smoothly.

The position of the front and back sides of the break is located below the drill belt, and the position is taken by the opposite position.

The notch on the front end of the cylinder has the function of increasing the opening and closing function besides modeling.

The AB line at the front of the cylinder is directly connected to a straight line.

The front and rear two lines are the zipper location line of Li Huai, and the front is also a broken line outside.

A zipper tongue part is arranged on the zipper side of the Huai side.

Other designs are high waist shoes.