Introduction To Shoe Sole Design

　　 Outsole It is the main component of leather shoes. It bears all the pressure of the human body when walking and working, and is directly rubbed against the ground. Therefore, when choosing material, it should consider its fastness and thickness, so as to consider folding resistance. Wear-resisting And other properties.

The outsole is related to the structure of the shoe, such as through the seam, pressing the palm, rolling the heel, wrapping the edge, wrapping the bottom, the welt, the inserting, the disc, etc. all kinds of process structures are different in design. The design of the outsole is based on the inner bottom. When designing, the thickness of the leather and shoe lining should be taken into consideration. The thickness of the material should be increased, and the thickness of the material should be reduced.

Design of welt

The welt is Leather shoes decoration A very important component. The welt is divided into semi - border, uniform and so on. It can be glued and stitched on the process. Materials can be made from genuine leather, plastic, rubber and regenerated leather. It has plane, inclined plane, triangle, gear shape, circle and so on.

I. design of wire rod

Wire rods belong to the auxiliary parts of the heel outside the welt. Generally used for men's shoes sewing products. Since the rear part has been stretched, its mouth has already been semicircular. If the heel is installed, it is easy to have cracks, so it is necessary to add a slope shaped wire rod around the heel to match with the back support.

The width of the general wire rod is 18-20mm, the length is 200mm, the thickness is 3mm, the 2mm is left on the wire rod plane, the remaining wide pieces are turned into residual slope, and the edge outlet is exported. When machining, pay attention to the size of the disc. Materials can be made from yellow or leather substitute.

Two. Design of enclosure

The round bar refers to the surround strip sticking around the leather shoes, and its decoration is very strong. For example, the vulcanized shoes and the thick edge of the adhesive shoes should be determined according to the height and length required.

Three. Design of dental bar

The design of the dental bar is a design of a small tool. Generally, a small tool is designed according to the shape and size of the tooth. The tooth strip is usually applied to the inner part of the welds, its total width is 16mm, the middle half is deep 2.5mm, and the width is 6mm. In the middle, the rollers are split into two parts in the middle, that is, the tooth shaped stickers, and the other way can be directly pressed by the die.

The components used in the bottom making process, including the main heel installed in the upper, the inner Baotou and other components, are collectively referred to as the bottom parts.

The design of sole parts is a simple plane at the bottom of the bottom part, which seems to have little change, and its shape is relatively simpler than that of the side. However, if the design is improper, it will also bring serious quality problems. Especially today, the competition of shoes is not only the competition of style and last shape, but also the competition between bottom and bottom. Therefore, the bottom design is an important link in the design of shoes.