Clothing Collar Collar Collar Method

Collar is an important part of the upper garment. Because it is located in the most sensitive part of people's visual range, people often pay special attention to it.

Whether the appearance of a collar is beautiful, whether the structure and technology are in place, can hardly escape people's eyes.

In especial

If the matching method is not proper, it will cause the crevice collar or Lapel not to be close to the body, which will seriously affect the finished product's quality and clothing effect.

Therefore, a reasonable collar can be used to create a good collar for the whole assembly.

The following will introduce a simple and practical collar collar collar, not for clothing lovers.

The characteristics of this matching method should be applied to the structure of the lapel collar in the Ping Bai structure.

1. make the collar design on the front garment piece according to the style chart.

Set up:

Width b=4 cm, collar height a=3 cm.

From the neck shoulder point (SNP), extend the shoulder suture to A point to the right. The value is 0.8a=2.4 cm. Connect the A point to the refute point (the first button button) and extend it to the barge line.

(3) from A point, shoulder point to 0.2a+b=4.6 cm.

From this point, we start the collar modeling.

4. Use the rebar line as the symmetry axis to make the symmetrical figure of the collar type and draw it well.

。

2. make the back collar and the outer line.

(1) from the point of cervical vertebra (BNP) to b-a=1 cm, then the neck shoulder point (SNP) should be placed along the shoulder line to the right shoulder.

(2) use the curve part of the multifunctional clothing special ruler to connect the two points that have been fixed and draw the outer line.

And its length is "".

At the same time, the neckline arc length "O" is measured.

3. draw the collar structure chart on the front garment piece.

(1) from the A point to the right shoulder point 0.9=2.7 cm, the fixed-point is C point, and connect C.B two points.

(2) take the C point as the center of the circle, take the CB as the radius to draw the arc upward, and then from the B point to -O+ (0.3-0.8) cm (thin material 0.3 cm, raw material 0.5 cm, thick material 0.8 cm), intersecting the arc line at B1 point, connecting C B1 two points.

C point upward for C B1 line.

After selecting the value, the arc length "O" is fixed at C1 point; then the C1 point is used as the perpendicular line of the C C1 line to the right, and the value is a+b=7 cm. The fixed point is C2 perpendicular to the C1 C2 line.

(4) use the multi-function special ruler to draw the right part of the curve bottom and the outer line of the collar to complete the drawing.

This method can also be used for matching.