Practical Clothing Collar Collar Collar Method

Collar is

An important part of it, because it is located in the most sensitive part of people's vision, people often pay special attention to it.

Whether the appearance of a collar is beautiful, whether the structure and technology are in place, can hardly escape people's eyes.

Especially for the collar, if the matching method is not proper, it will cause the crevice collar or Lapel not to be close to the body, which will seriously affect the finished product's quality and clothing effect.

Therefore, a reasonable collar can be used to create a good collar for the whole assembly.

The following will introduce a simple and practical collar collar collar, not for clothing lovers.

The characteristics of this matching method should be applied to the structure of the lapel collar in the Ping Bai structure.

1. make the collar shape on the front garment sheet according to the style chart.

。

Set up: the lapel is b=4 cm wide and the collar is a=3 cm high.

From the neck shoulder point (SNP), extend the shoulder suture to A point to the right. The value is 0.8a=2.4 cm. Connect the A point to the refute point (the first button button) and extend it to the barge line.

(3) from A point, shoulder point to 0.2a+b=4.6 cm.

From this point, we start the collar modeling.

4. Use the rebar line as the symmetrical axis to make the symmetrical figure of the collar type and draw the front neckline.

2. make the back collar and the outer line.

(1) from the point of cervical vertebra (BNP) to b-a=1 cm, then the neck shoulder point (SNP) should be placed along the shoulder line to the right shoulder.

(2) use the curve part of the multifunctional clothing special ruler to link two fixed points, draw the shape of the rear collar outside the mouth line, and make the length of it.

At the same time, the neckline arc length "O" is measured.

3. draw the collar on the front piece.

。

(1) from the A point to the right shoulder point 0.9=2.7 cm, the fixed-point is C point, and connect C.B two points.

(2) take the C point as the center of the circle, take the CB as the radius to draw the arc upward, and then from the B point to -O+ (0.3-0.8) cm (thin material 0.3 cm, raw material 0.5 cm, thick material 0.8 cm), intersecting the arc line at B1 point, connecting C B1 two points.

(3) C points up the vertical line of the C B1 line. After the value is chosen, the arc length "O" is fixed at C1 point; then the C1 point is used as the perpendicular line of C C1 line to the right, and the value is a+b=7 centimeter.

(4) use the multi-function special ruler to draw the right part of the curve bottom and the outer line of the collar to complete the drawing.

The collar can also be matched by this method.