Design Guide For High Waist Men'S Shoes With External Ears

Designed high waist with outer ear shoes The pattern is: contour of high waist shoes+structure of outer ear shoes.

1. Finished product drawing

As shown in Figure 5-1-6, this is an ordinary external ear type High waist men's shoes There are 5 eye positions, and the back upper is composed of shoe eye strip, mouth guard strip and gourd shaped back heel. The contour of the back upper should be designed first, and then various parts should be designed according to the design rules of the outer ear shoes.

The back upper height is 90~llOmm, and the toe opening length is 120~125mm.

2. Structural design drawing

As shown in Figure 5-1-7, the operation steps of drawing the structure diagram are as follows:

(1) To determine the height and length of the back wall, determine the orientation of the half panel on the rectangular coordinates, connect four basic control lines, and mark the natural crossing.

Measure the back upper height llOmm upward from the last heel height B 'point, and make the vertical line of the longitudinal axis:

Set point y ≥ 5mm at the rear end of the last opening.

At the back arc position, determine the point C plus 2mm, the point D plus 3mm, the point B plus 5mm, and then connect with the point y to form a smooth curve slightly in the shape of S, and intersect with the vertical line passing through the longitudinal axis at the T 'point.

Measure 120mm forward from T 'point, and then increase 7~10mm to T' point. The length of T 'T' is Toecap The basic length of.

(2) Determine the contour line of the shoe ear and the shoe mouth Since this shoe is an outer ear type shoe, the contour line of the shoe ear is close to the back center line of the last surface but does not overlap, so first determine the front cusp of the outer ear.

The early ear type high waist shoes often appeared as labor protection shoes and work shoes. In order to make it easy to wear and take off, the front cusp of the outer sleeve is relatively forward, and it is designed to be 5mm below the o point. Now when designing fashion shoes, you can move back about lOmm and still control the position 5mm below the OQ line.

In the included angle range where T 'is the vertex, first design the ear circle arc, then design the second circle arc diagonally downward in front, and then connect it to the outer O1 point. The egg is connected with the lower arc.

The design of the toe line is the same as that of the inner ear high waist shoes. The toe line should be different from the inside and outside.

The edge distance of eye position line is 15mm, and five eye positions are equally divided, and the eye strip parts are divided at the position equivalent to the false line (12-15mm).

The mouth guard is designed with a width of 12~l5mm, similar to the width of the false line. Since the mouth guard strip does not open at the back middle seam, the length of 1mm shall be added as the processing amount.

The gourd shaped back heel is designed, and the upper end of the back heel part is taken as a straight line along the center line of the back arc, with no need to retract 2mm. After measuring the actual height of the hoist, directly draw the width line. As shown by the dotted line in the figure.

After completing the design of the outer sleeve side, determine the 02 point position and make the difference between the front cusp of the outer ear and the inner and outer sleeve.

(3) For the design of the front upper, the contour line of the front upper is determined according to the amount of stubble pressing of 8mm, and the O 'point of the width of the fixing door is 15~20mm away from the shoe ear.

Design the broken tongue position shoes tongue The contour line and tongue length are based on the eye position line.

The midline on the back of the front upper is designed by using the positioning and pick up.

The treatment of bottom opening is the same as before.