Operation Essentials Of Laser Cutting Machine

As a high-end garment processing equipment, such as clothing, luggage, automobile decoration, etc.

It has been applied by many enterprises and its popularity has been improving.

However, for laser cutting machine operation problems, if not pay attention to, easily lead to frequent failure of clothing equipment, so operators still need to improve.

Next, according to my own experience, the author will talk about some matters that must be known in the process of laser cutting machine operation.

1. observe the safety operation rules of general laser cutting machines.

We need to operate the laser cutting machine in strict accordance with the laser startup program.

2. operators must be trained, familiar with the structure and performance of clothing equipment, and master the relevant knowledge of the operating system.

3. wear protective clothing according to regulations, and wear protective glasses that meet the requirements near the laser beam.

4. before making sure that a material can be irradiated or heated by laser, do not process it, so as to avoid the potential danger of smoke and vapour.

Five

When the equipment is switched on, the operator shall not leave the post without authorization or wait for the management. If he really needs to leave, he should stop or cut off the power switch.

6. place the fire extinguisher in accessible places; turn off the laser or light when not working; do not place paper, cloth or other combustible materials near the unprotected laser beam.

7. in the process of finding abnormal, the machine should be shut down immediately, troubleshooting promptly or reporting to the supervisor.

8. keep the laser cutting machine, the bed and surrounding areas clean, orderly and free from oil pollution. The work pieces, plates and wastes are stacked according to regulations.

9. when using gas cylinders, avoid damaging the welding wires, so as to avoid leakage accidents.

The use and pportation of cylinders should comply with the gas cylinder monitoring regulations.

Gas cylinders are not allowed to explode in the sun or near the heat source.

When opening the bottle valve, the operator must stand on the side of the bottle mouth.

10. the high pressure safety regulations should be observed during maintenance.

It should be carried out in accordance with regulations and procedures.

11. after starting, manual low speed X and Y direction should be started to check the machine and check whether there is any abnormal condition.

12. after the new workpiece program is input, it should be run first and check its operation.

Thirteen

At work, we should pay attention to observing the operation of the machine tool, so as to avoid the laser cutting machine going out of the effective travel range or the two stations colliding and causing accidents.