PTA Profits Are Compressed And Downlink Space Is Limited.

The absolute value of upstream PTA industry operation rate is not high, but slightly overabundant compared with polyester industry. Downstream polyester production and marketing continues to slump, prices fall, the biggest problem is excessive losses.

This situation has lasted for 5, 6 and two months.

Polyester and PTA processing profits have also been squeezed.

Taking PTA as an example, from the profit and loss situation of three months from 4 to June, the average price of PX in April was 919 US dollars / ton, plus 500 yuan / ton processing fee.

The cost is 4902 yuan / ton, the average PTA spot price is 4895 yuan / ton in that month, the ACP of PX in May is 925 dollars / ton, the corresponding PTA cost is 4922 yuan / ton, the average spot price is 5065 yuan / ton in that month, the average price of PX in June is 936 US dollars / ton, the corresponding PTA cost is 4985 yuan / ton, and the average spot price in June is 4950 yuan / ton.

If the processing fee of a small enterprise is 700 yuan / ton, it has lost three months.

Therefore, if PTA is currently available

Down again, the PTA plant will reduce production and stop parking, while the absolute value of PTA's operation rate has been very low, and the reduction of production will certainly increase the PTA price.

New PTA in the future

Very limited, and since March, the PTA plant has gone bankrupt, and the current price drop is likely to be the last drop.

In short, shale oil production in the US is stable and production decline is expected to support crude oil prices.

Affected by systemic risk, the price of PTA has broken down, but the profit margins of PTA and pet have been greatly reduced. From the perspective of industry cycle, PTA will not trend downward trend.

Related links:

With the rapid development of the individuation and quality of textile products, the quality requirements of the downstream enterprises of cotton textile have improved.

Due to cost and other factors, cotton textile enterprises will consider making some scientific and reasonable adjustment in raw material blending with cotton spinning.

Therefore, Zhejiang Jinfeng Textile Machinery Co., Ltd. has developed the JZX - "5" comb, sawtooth combined high efficiency comber comb.

According to the performance and sawtooth characteristics of the comb pin, the circular comb design of the high efficiency cotton comber is optimized and the carding ability is further improved.

However, combing fiber needs combing force, and the carding force is not enough, which will cause the fiber bundles not to open, resulting in fiber bundles. Too much combing force will lead to fiber damage, increase short staple, aggravate the abrasion of the needle teeth, even break the needle and break the teeth, and increase the energy consumption of the equipment.

Therefore, the design of the circular needle and saw tooth has been greatly improved. The round comb needles ensure the sharpness and roughness of the front end, and ensure the taper of the rear end. The saw tooth piece adopts the technology of stamping and grinding on both sides of the tooth surface to ensure the smooth tooth tip, tooth root and tooth surface.

At the same time, in order to adapt to the high speed and large quantitative process requirements, avoid inserting, loosening and finishing of the front row sawtooth puncture cotton layer, and better integrate the advantages of the needle cylinder and the sawtooth cylinder to ensure the best puncture effect.

The needle tooth height of the needle bar and the tooth piece is deep and shallow in the front row, which reduces the filling of the fiber to the cylinder and improves the carding effect of the fiber and cylinder.

Such a tin Lin design, consciously Sn forest is divided into two areas, to ensure the high speed of the carding quality, and also can be applied to various types of cotton combed mainframe.

With the increasing demand for semi finished products and yarn in cotton textile enterprises, how to meet the requirements of users and improve the quality and quality of products is a systematic project.

Zhejiang Jinfeng should further improve the quality management network, strengthen the quality control points of the production process, and do well in the production.