Basic Operation Of Garment CAD Technology Collar Making

utilize clothing CAD software pair clothing The modification of components is very simple. The following describes how to use several special tools in the stamping process to make them. When the middle number plate making is completed, the other sizes will be automatically generated.

The specific steps are as follows:

1. Press the Ctrl key at the same time with the [Random Move] tool to copy the completed front and rear pieces of cardboard.

?

Fig. 4-3-32

2. Press the Shift key after the [Specify Movement] tool, and the tool will change to [Rotate Movement]:

Frame select the rear panel; Indicate two points before moving: neck shoulder point and shoulder point of the back piece; Indicate two points after moving: neck shoulder point and shoulder point of front piece; Click to bring up the dialog box of "rotation movement setting": select "rotation amount", enter 0 in the length input box, the front and rear shoulder lines are one line, or enter other values such as 2, the front and rear shoulders overlap 2cm at the shoulder point, See Fig. 4-3-33;

Fig. 4-3-33

Fig. 4-3-34

3.1) [Curve] tool:

From the -0.7cm position outside the back collar to the 0.6cm position outside the neck shoulder point, and then to the 13cm position below the original collar depth, right click to confirm, as shown in Figure 4-3-34;

2) [Connecting angle] tool: the back center line and the back collar curve form an angle, as shown in Figure 4-3-34;

4. 1) [Delete] tool: delete the original leading curve;

2) [Vertical line] tool: make a 16cm vertical line at the position 10cm from the back center line to the end of the back leading curve to be perpendicular to the back center line, as shown in Figure 4-3-35;

3) [Curve] tool: draw a curve from the left end of the newly made vertical line to the lower end of the front neckline curve, as shown in Figure 4-3-35;

{page_break}

Fig. 4-3-35

Fig. 4-3-36

　　5. 【 Cloth sheet Take out] tool:

Take out the shape of the navy collar, and select "Reference line parallel" in the "Yarn direction configuration mode" in the "Cloth taking out" dialog box. At the same time, pay attention to selecting "Sheet unfolding" and "Generate cloth", as shown in Figure 4-3-36;

6. The method of wave collar is the same as that in steps 1 to 4 above. The size and width of the collar are determined by the board maker according to the style needs.

{page_break}

Fig. 4-3-37

Fig. 4-3-37 (2)

7. [Cloth taking out] tool: do not select "generate cloth" when taking out the collar shape, as shown in Figure 4-3-37;

8. [Split] tool:

In the division dialog box, the division type is equal division; Segmentation method: quantitative rotation segmentation; Number of divisions: 10; Rotation length: 2; Select all collar elements in the box, indicate the inner collar curve and then the outer collar curve, and complete the opening, as shown in Figure 4-3-38;

?

Fig. 4-3-38

9. [Splicing] tool:

Multiple broken lines of the outer collar are pieced into a curve; Multiple broken lines of the inner collar are pieced into a curve;

[Delete] Internal split line, complete Wave collar See Fig. 4-3-39.

?