Method And Skill Of Adjusting Shuttle Bed Of Embroidery Machine

The adjustment of the shuttle bed is actually to adjust the best position of the upper shaft and the lower shaft. In principle, it can only take the bottom line after forming the line loop. In this process, it involves three positions and 1. TDC. 2. dead end. 3. Take the line bit. That is to say, the needle bar runs to the highest point, the lowest point and the bottom line of the shuttle bed. In these locations, the most important thing is to take the line bit. Generally speaking, the adjustment of the shuttle bed is actually adjustment. Take line Before adjusting, the upper and lower stops must be adjusted. The needle must be upright.

　 Adjust line level steps

1. first, the dial is moved to the tick scale.

2. press the needle bar down, right on the nose and 45 degrees angle, you can see that the half pin hole is the best position of the needle bar.

3. adjust the shuttle bed and needle tip position. The needle point is right. Shuttle bed Take the thread hook point, lock the screws to move around and move the shuttle bed needle tip to cover the spindle bed hook tip as the best position.

4. adjust the distance between the shuttle bed and the tip of the needle (the distance is too wide to take up the bottom line).

Attention, usually we will adjust the shuttle bed with needle No. 5, then use the needle No. 2 and pin 8 to position again. The shaft of the machine is broken and the shaft is broken, and the result is always broken.

The other is to make sure that the shaft of the take-up rod is installed or the axle which drives the half tooth is changed. If the shuttle bed and so on are all changed, for this reason, the company has made detailed analysis and statistics, providing the parts with the principle of solving the customer's difficulties first, and sending them by courier on the day of receiving customer's parts demand, and ensuring that their positions are all normal. Well, that's very likely. Embroidery machine The rubber cam or the iron cam has been moved or damaged. It is better to find professional maintenance personnel.