How To Make Embroidered Plates Of Costumes

clothing

The way of fixing.

Generally, there are two ways of fixation: Y fixed and one font fixed.

It can also be freely implemented on demand.

In the two fixed ways of application, the Y fixed pattern is usually used in the embroidered work of sequins, and the single garment sequins are embroidered. The fixed pattern of one font is usually used in the form of a single line to connect a group of clothing sequins.

You must press the gold status button ahead of time when making the sequins.

As mentioned in the above basic knowledge points, we must press the gold status button when we want to play the clothing sequins.

But if the next drop point is to drop the garment sequins, and press the gold status button from the drop point, this will not work.

As the sequins of clothing sequins are driven by air compressors, if the air leakage or air flow is insufficient, the placement of clothing sequins can not be in place in time, so that the placement of sequins will not succeed.

Therefore, in order to avoid this situation, the current solution is to put the sequins in front of the 50~100 pins before placing the sequins.

The choice of bright and thin clothing

In the usual business card printing, it is not a one-time finish of flat embroidery to play the sequins of clothing, but not to finish the sequins of clothing and then to make flat embroidery.

If finished

Sequins, we need to carry out a piece of flat embroidery, and then we need to play the sequins. In the middle flat embroidery, it is a matter to consider carefully that the garment is bright and thin.

If the number of needles in the middle flat embroidery is not large, generally no more than 1000 needles.

If there are more needles in the middle, it is better to lift the top of the garment.

The former is not because of the larger proportion of the time spent in embroidering the front of the garment and the time when the clothes are put down.

The latter should be lifted because the number of needles is too large, and the thread will inevitably break, and if the garment is bright, if it is not lifted, the thread will be more troublesome.

Coordination of the relationship between closing the garment bright head and shearing device when locking the needle

clothing

It is necessary to lock the needle because the needle at the top is at least 3.7 millimeters.

Therefore, if the needle is not firmly locked, it will lead directly to the falling film.

Usually use a short needle to pin the needle back and forth.

If you do not play the sequins of clothing, or you need to spend some time on the flat embroidery, you should lift the top of the garment, and pay special attention to lifting the relationship between the sequins and the shears.

The general principle is to lift up the front of the garment before cutting the line.

Otherwise, the cutting device will encounter the bright head of the garment.

Moreover, because the wire cutting device is driven by the spindle motor, and the garment's bright head is driven by air flow, so if you want to cut the line, it is best to lift the clothing head when the needle is 50~100 needles.

Clothing sequins are slightly more difficult than other special embroidery.

Because there are many problems that must be considered. As mentioned above, the relationship between the cutting mechanism and the bright part of the garment is that some novice will cut the thread when they do not lift the head of the garment, so that they will crash the garment, so that the clothing sequins are not in place or the needle is placed on the sequins, rather than the holes in the middle.