The Two Way Of Weaving Slippers Is Easy To Learn.

The first weaving method

First use on sole.

Hook up.

Then start the hook.

。

When hooking, the toe of the shoe is always toward itself, and every line is drawn from the right to the left.

Choose the 10 pin in the middle position (the first 12 needles for men's shoes), and leave a line on the left.

The vamp is made of double long needle hooks, that is to hook two long needles in one hole, so that the 10 needles will be hooked up to 5.

After the hook is finished, use the reserved thread to go through the last needle and tighten.

Pull the line to the right, and set aside a certain amount.

It is similar to the height of the vamp.

Then hook, second rows to hook in the middle of the first row out of the hole, third rows of hooks in the first row of two long needle in the middle, has been so hook down, hook more than 2 lines.

。

6, hook can hook some tricks, hook to the length of your favorite.

Second methods

1. First, hook up on the bottom line.

2, use the wool thread hook on the bottom line, (if you want to have a little bit, you can use two line hooks) hook four rows, heels do not hook four rows.

The bottom of the cloth is made of two rods and needles. The needle is formed according to the shape of the bottom. According to the thickness of the wool and the size of the sole, the needles are woven into second rows. Each side is added with one needle to form a fillet. The place where the width is added is added with one stitch. It can not be added too much. The bottom of the fabric is best to be smaller than the sole.

(for two purposes)

Woven together, you can use two threads to weave at the same time.

And sew the bottom of the fabric on the sole: if there is thin

Put two layers on the bottom of the wool line (line the sponge and wool line in the middle from top to bottom).

Needle: toe to face.

To leave a thread that is slightly longer than the sole of the shoe, start with 5, 6, or 7 stitches according to the size of the sole.

In short, the two sides should not be skew.

If one side is uneven, it can be separated by braids and not separated. Sometimes it can be separated by two plaits.

Flexible use.

Depending on the height.

First needle hook short needle, then another one.

In the third plaits, two needles and long needles (a large needle) are separated by a single braid, fifth needles, two needles, long needles, and so on.

Hook to the end and hook a short needle, and then pull the thread from the short needle loop to tighten.

Again, the needles mentioned above are large needles.

The first needle of the middle and long needle of the second row is in front of a big needle, and the second needle is in the braid needle below. (if the wool is thin, it can also hook the two needles underneath, so it will be thicker.

The first needle of the middle and long needle of the third row is the same as above, and the second needle hook is in the middle of the two middle and long needle of the next row, and so on.

Remember.

The first and last stitches of each row are

。

In order not to have high or low vamp, do not hook each pigtail.

If each braid is hooked, the vamp will be raised.

Hook flower: to choose the size suitable for the sole, try to hook in the middle, the general size.

It starts after three big needles.

Attention: symmetrical before and after, there should be three big needles before and after.

The hook is more than 20 rows (23, 24 rows of sole longer points will be more). When changing color lines, the two middle and long needles are exchanged for one stitch.

Finish: after hooking, hook one row or two rows of short needles.

There is another way.

Very thick.