Ultra Lightweight Injection Molded Rubber Soles Are Favored By The Market.

Thailand of Jinjiang shoes Since its establishment, the company has been concentrating on the introduction of advanced production equipment and technology, producing various kinds of shoes, producing ultra light TPR soles, PVC blowing foam sole, rubber injection sole and ultra light injection rubber sole. Among them, ultra light injection molding rubber sole, referred to as VR, is a new product developed by Thailand shoe materials to meet the needs of social development.

According to Xie Song, general manager of Thailand shoes materials, the idea of ultra light injection molded rubber soles comes from Santoprene, the dynamic vulcanization technology of Monsanto. Compared with traditional rubber, ultra light injection molding rubber has several advantages: first, the proportion is about 0.97, which is more than 20% lighter than that of traditional rubber. This is also the most important advantage. Two, the wear resistance and folding resistance are more than that of conventional rubber, one hundred thousand times below ten degrees, three is the production cycle is fast, the traditional rubber should first go through rubber making, adding vulcanizing agent, then molding and heating, and finally producing rubber. "What I have to do is to make good granules first, do not use glue, and do not need vulcanization, directly injection through the disc machine, directly forming, making ten thousand pairs of sole by traditional rubber may take fifteen days, but we can use this thing (super light injection rubber), five days to seven days, we can finish it," Xie Zong confidently said. "Four is no frost, super light injection rubber is made of oxidant, unlike traditional rubber is sulfurized."

When it comes to ultra light Injection molding rubber The market prospect, "the market prospect is not easy to say, I certainly hope it is good," Xie general said humbly. Ultra light injection rubber as a new technology, one is truly environmentally friendly, not only reduces energy consumption, but also can recycle the leftover bits and pieces, so that shoe sole can be recycled and reused; two, it reduces the labor intensity of workers, and the working efficiency is two times that of the original; three, it is speculative small, ultra light injection molding rubber requires more raw materials, but the investment of equipment is relatively low, the traditional rubber needs a complete set of nearly 2 million equipment, ultra light injection molding rubber only needs a 200 thousand disc machine, the performance of the sole is not worse than the traditional one, and the price is the same. It can reduce the energy and the intensity of workers without increasing the cost. This should be in line with social development and will occupy a place in the shoe material market.

"At present, Nike, ADI And other international brands are also studying, but their demands are relatively high. We are now on the same line with the international community. Maybe I will go relatively fast. The technology to achieve these advantages, mainly in the production process, and now there are no more than 20 technical engineers who can fully grasp the core secret of the technology in China, "Xie Song, general manager, explained.