Market Prospect Of Ultra Light Injection Rubber Sole

< p > Jinjiang a target= "_blank" href= "http://www.91se91.com/" > shoes < /a > Material Co., Ltd. since its inception, has been focused on the introduction of advanced production equipment and technology, the production of various kinds of shoes, have produced ultra light TPR soles, PVC blowing foam sole, rubber injection sole, ultra light injection rubber sole.

Among them, ultra light injection molding rubber sole, referred to as VR, is a new product developed by Thailand shoe materials to meet the needs of social development.

< /p >

< p > according to Xie Song, general manager of Thailand shoes material, ultra light injection molding < a href= "http://cailiao.sjfzxm.com/" > Rubber > /a > soles is originated from Monsanto's Santoprene, namely dynamic vulcanization technology.

Compared with traditional rubber, ultra light injection molding rubber has several advantages: first, the proportion is about 0.97, which is more than 20% lighter than that of traditional rubber. This is also the most important advantage. Two, the wear resistance and folding resistance are more than that of conventional rubber, one hundred thousand times below ten degrees, three is the production cycle is fast, the traditional rubber should first go through rubber making, adding vulcanizing agent, then molding and heating, and finally producing rubber.

"What I have to do is to make good granules first, do not use glue, and do not need vulcanization, directly injection through the disc machine, directly forming, making ten thousand pairs of sole by traditional rubber may take fifteen days, but we can use this thing (super light injection rubber), five days to seven days, we can finish it," Xie Zong confidently said. "Four is no frost, super light injection rubber is made of oxidant, unlike traditional rubber is sulfurized."

< /p >

< p > when it comes to the market prospect of ultra light injection molding rubber, "I certainly hope it is good," Xie Zong said humbly.

Ultra light injection molding rubber is a new technology. First, it truly achieves < a href= "http://www.91se91.com/news/index_x.asp > environmental protection < /a >, not only reduces energy consumption, but also can recycle leftover materials, so that shoe sole can be recycled and reused; two, it reduces labor intensity of workers, and the working efficiency is two times that of original ones; three, it is speculative small, ultra light injection molding rubber requires more raw materials, but the investment of equipment is relatively low, the traditional rubber needs a set of nearly 2 million equipment, and ultra light injection molding rubber needs only a 200 thousand disc machine, and the performance of the sole is not worse than the traditional one, and the price is the same.

It can reduce the energy and the intensity of workers without increasing the cost. This should be in line with social development and will occupy a place in the shoe material market.

< /p >

"P >" at present Nike, ADI and other international brands are also studying, but their requirements are relatively high. Now we are on the same line with the international community, maybe I will go relatively faster.

The technology to achieve these advantages, mainly in the production process, and now there are no more than 20 technical engineers who can fully grasp the core secret of the technology in China, "Xie Song, general manager, explained.

< /p >