Analysis: Press The Bottom Of The Shoe To Make The Shoe Press Better.

One

Each action has an external handle pressure regulating function to perfect the bottom of the shoe.

2.. The hydraulic press system is designed for the bottom of the dragon boat and the bottom of the wall.

And the soles of the casual shoes are pressed.

Pressing, pressing and pressing can be completed or individually completed at once. The output is large and the bonding is firm. Besides saving labor, it is uniform and effective. It is an automatic pressing equipment for the upgrading of shoemaking industry.

3. automatic balance bar and deflection mechanism: two pressure bars adjust the structure of oil pressure automatically and adjust the height and height of shoe last, and ensure that the pressure of two pressure bars is average, so that the force of sole is more uniform.

The two strut can swing at the same time.

In order to remove the shoe last, it is necessary to change the old machine press bar into a fixed type, so that it can not operate conveniently.

4. pressure mechanism: the press on both sides of the shoe last adopts the full oil pressure action. There are nine rubber foam blocks on each side. The shoe type can be pressed on the wall at any time with different sizes, and each pressing block is pushed by an independent hydraulic cylinder. Each pressure can reach up to 250-300KG, and there are two groups before and after each block.

Adhesion is the best way to pay.

5. increasing the oil pressure cylinder by using the pre charge valve to replenish the oil quantity, can increase the operation speed, save the operation time and increase the economic efficiency.

6. the pressure bar mechanism of the press machine adopts the automatic balancing system of the oil pressure. The height of the pressure bar needs no adjustment, and the operation is simple.

7. the automatic positioning design of the pressure bar mechanism can make the shoes easy to take and easy to handle, and the long or half long shoes are also very convenient to operate.

8. before and after the tightening mechanism is retreated, special circuit design is adopted to control the backoff distance and to replace the shoe size easily.

How to use the press?

First, open the power supply of the bottom press, start the machine, adjust the distance between the press bar and the front and back, and the other departments adjust according to the needs.

Two. Select the corresponding gear of the required action switch.

Three, put the shoes on the rubber pad, and put the liner according to the corresponding radian, all adjustments can be operated.

Four, press the manual button, the pressure bar moves across, the big seat rises, each part moves in order, the pressing time is: 8-10S.

Five, the end of time, the machine action restore, check the pressure shoes, adjust the machine as needed, until the shoes are compacted, not empty, not super line, not degumming;

Six, matters needing attention: cleaning the oil tank and antirust oil.

Open the fuel tank cover, add hydraulic fluid (China Petroleum Corp R-68#) about 100 kilograms, and keep the hydraulic oil clean. The oil surface should be higher than the oil filter cylinder 30mm, which is lower than the oil tank surface 30mm.

The hydraulic oil of the new fuel tank should be replaced after 800 hours.

After every 2800 hours of work, replace the hydraulic oil to ensure the normal operation of the machine. Connect the power supply (300V, 50HZ) and pay attention to the protection of the grounding wire to ensure safety, turn on the power supply, start the motor, the total pressure of the pressure gauge is 30kg/cm ~50kg/cm, and the pressure must be the same.

If the pressure is reversed, the motor can only be replaced by a two phase power supply. The motor runs ahead of time for 5 minutes, so that the oil temperature reaches 10 degrees C (50F).