Main Features Of All Air Sandals Last

The whole air sandals are different from the last ones. The overall feeling is that the soles are shorter, the front is thin, the body is fat, the toe is short, and the heel is wide.

The length of the 1. last sample is short

Because toe is exposed when wearing sandals, too long allowance is neither elegant nor conducive to walking. Therefore, the allowance for men and women's sandals is relatively small, which makes the length of the last bottom sample shorter.

The rear tolerance of all air sandals is also smaller, so as to increase the width of the last bottom heel chassis and facilitate the holding of exposed heels.

Men's 250 and two half last 255mm are long, with the allowance of 9mm and tolerance 4mm.

Female No. 230, middle heel, and half last last 237mm are long, with a allowance of 10. 5mm and a tolerance of 3.5mm.

Why is the allowance for No. 230 female last item larger than that of No. 250?

The outsole of general air sandals is not out of border type, and the outsole of male sandals is out of type. From the effect of wearing, the length of toe from the bottom edge is longer than that of men's sandals.

2. the last tarsal girth is big.

The sole of the shoe last is smaller, and its predecessor is thinner.

The upper side of the sandals is bigger. The last body is more fat. It is designed to meet the requirement of shoelace length and to solve the problem of foot pressing.

The increase in the ability to hold the feet after the empty sandals is achieved by tightening the shoelace. The length of the back can be adjusted. Even if the shoe last body is more fat, it can keep up with the shoelace.

This is different from the length of full back shoes.

Men's 250 and two half last 236mm last girth, and the length of tarsal girth with height 20 and 35mm is 244mm and 243mm respectively.

The sole of male sandals is similar to that of tongue type last, and the tarsal girth is similar to that of vegetarian head last. It is slightly more than 0. 5mm.

The length of the plantar girth of female 230 and half last is flat heel 213mm, middle heel 215mm and high heel 217mm. The length of the tarsal girth is 20 to 80mm from the heel height: 221, 219, 218, 216, 214, and 212mm respectively.

The change of the plantar circumference of the sandal last type is similar to that of the female shallow mouth. The change of the tarsal girth is similar to that of the female head last, and is slightly more than 0. 5mm.

3. the thickness of the last is low.

The thickness of the shoe last is lower than that of the full last, because the toes are exposed and do not use the former Baotou, so it does not need to use the higher head thickness to maintain the shoe cavity capacity.

Men's type 250 and type two half last 17mm thick, lower than 3mm last.

Female 230, one half and half last 15mm thick, lower than 1.5mm.

That is to say, do not use all air sandals when designing front sandals, or they will cause grinding toes.

Through the analysis of the whole air sandal last, it can be seen that there is a great difference between the whole shoe last shoe and the shoe last shoe, so it can not be mixed.